Access Point Configuration
1. Wi-Fi Access Point Configuration
To change the access point settings, it is recommended to access Raspberry Pi locally.
First, find the local IP address assigned to your Raspberry Pi by your main router.
Then connect your computer or smartphone to the same main router and open the IPArmor web panel using the assigned IP address.
This allows you to configure the access point without having to reconnect to the Raspberry Pi Wi-Fi network after every change.
In the Wi-Fi section you can configure:
- Network name (SSID);
- Password;
- Access point MAC address;
- Transmit power (from 1 to 31, where 31 is the maximum power)
- Wi-Fi channel;
- Wi-Fi band.
⭐ Recommended: Use the 5 GHz band whenever your devices support it for maximum speed, connection stability, and reduced interference.
2. Changing the MAC Address
The MAC Address section allows you to change the MAC address of any Raspberry Pi network interface.
This helps modify the device’s network environment and prevents reusing the same network identifiers across different configurations and devices.
Change the MAC address of the interface that is operating in Distribution Internet mode. This is the MAC address that devices connected to the Raspberry Pi will see.
For MAC address generation, use the MAC Address Generator: https://404.vodka/mac-generator/
The service allows you to generate MAC addresses based on device and manufacturer profiles, as well as specify a custom prefix.
After Changing the MAC Address
After changing the MAC address, the internet connection may temporarily be unavailable.
This is normal because your router re-registers the device and may assign it a new local IP address.
If the connection is not restored automatically:
3. Changing the Local Subnet (Local IP)
For interfaces operating in Internet Sharing mode, you can manually change the local subnet.
This can be useful because some anti-fraud systems analyse local network addresses as an additional factor during device evaluation.
Supported Ranges
After changing the Local IP, when connected to the Raspberry Pi access point, the IPArmor web panel will be available at the new IP address, for example:
Do Not Use Addresses That
- are already assigned to other Raspberry Pi network interfaces;
- are used by the interface through which the Raspberry Pi accesses the Internet.
Doing so may cause routing conflicts and loss of access to the device.
The Following Subnets Are Not Recommended
These subnets are commonly used by home routers, LTE modems, PPTP, OpenVPN, and other VPN configurations. Using them may result in routing conflicts, DNS issues, or loss of access to the Raspberry Pi.