It is difficult to return to its foldable walking pole company original state, and secondary plastic deformation is bound to occur

Common problem 1, my trekking pole is broken, and the tip of the stick fell off when I walked. Trekking poles are lightweight equipment. Under the premise of ensuring a certain strength, hollow aviation aluminum or carbon fiber tubes are used to control weight and volume. In terms of design, strength and light weight are contradictory objects. Down and achieve unity. These prerequisites lead to a certain loss ratio of climbing poles. Most of the reasons for loss are crushing, non-breaking, repeated wear and tear. Most of them are normal wear. In addition to manufacturers advancing standards through new materials and optimized designs, users also need to understand and pay attention. The long-term maintenance records of our team show that there are many breaks in the near-ground section of trekking poles, and the maintenance rate is the highest: in fact, although this section has the smallest diameter, the wall thickness is 0.1-0.2mm thicker than the upper two sections. Yes, because this section is close to the ground, the rocks are prone to wear, bumps, and easy to insert rocks. We also conducted analysis based on feedback from a large number of users. Normal use loss accounts for a large proportion. This is why some friends regard trekking poles as consumables. Therefore, it is particularly important to do a good job of daily inspection and protection. Regardless of the material, the equipment should be maintained in a timely manner. Before you can't stand it, don't blame it for you. Just as soldiers must always check their own firearms, equipment is the weapon of our ass lovers. One of the functions of the mud drag is to prevent the tip of the stick from getting stuck in the rock. During the maintenance process, it was discovered that some traveling friends were stuck in the cracks of the stone and damaged the stick and the tip of the stick because of the failure of the mud drag. The force is concentrated at one point, the principle of leverage, the result can be imagined. In summary, paying attention to daily maintenance and correct use of trekking poles can greatly extend the life of trekking poles. 2. Frequently asked questions 2. How to choose a trekking pole that suits you? For the group of traveling friends, trekking poles are used frequently, and they often carry heavy weights. When choosing trekking poles, try to avoid choosing 6061 and small diameter (16/14/12mm) trekking poles. 6061 is an entry-level product, suitable for low frequency, ordinary traveling and mountaineering; the thin tube trekking pole is a more lightweight design, suitable for girls with smaller weight. Choice of trekking pole length: 3. Question three, can the aluminum alloy trekking pole be used when it is bent? Straightening requires multiple processes, and the repair cost will be higher than buying a new rod. After being straightforward, I couldn't make money because I couldn't be very straight. Even if it can be paid, it will cause friction on the inner wall of the upper section of the tube, which will damage the inner wall of the upper tube, and it is not easy to detect. The strength of aviation aluminum alloy is very high, but for the needs of light weight, the wall thickness will be under the premise of ensuring a certain strength Be as thin as possible. When trekking poles are beyond the scope of normal use, such as being crushed by a person who fell down; or accidentally sitting on the butt; crushed during transportation; don't cut off when inserting a rock. . It may cause deformation or breakage of trekking poles. The hardness of 60617075 aviation aluminum is very high, and the tube wall is relatively thin. Once plastic deformation is formed, it is difficult to restore the original strength of the pipe at the deformation. The plastic deformation of the tubular body usually occurs when one side is stretched and the other side is squeezed. If it is corrected, it is difficult to return to its foldable walking pole company original state, and secondary plastic deformation is bound to occur. As a result, it is often broken or the strength is further destroyed. Moreover, it is difficult to correct the original tube to its original shape, and as long as it is slightly deformed, the tube cannot expand and contract smoothly. Friction occurs with the upper and lower pipes and causes further wear of the pipe walls of the upper and lower pipes. The most economical and safest solution is to replace a good tube.