Change the parameters of the computerized embroidery machine

The length of the short upper thread of the upper thread for trimming is closely related to the tension of the thread take-up spring and the adjustment of the thread path. Short cut bottom line Introspect the depth of the knife, the shallower the knife depth, the shorter the bottom line; Introspect whether the thread buckle fork can be buckled too tightly. Loss. The first thing to pay attention to is that the choice of needles for computerized embroidery machines. If the machine surface is not tightly closed, if the buckle wire has insufficient capacity and the buckle wire is not tight, it will also cause the thread to be cut.

If an inappropriate needle is selected, it will cause thread or needle breakage, which is very effective for embroidery factories. Introspect the depth of the knife, the knife is too shallow to cut the thread; Change the parameters of the computerized embroidery machine, and examine whether the line-dividing angle is between 310-315; In addition, there are some special reasons that can cause disconnection, even room temperature. If the thread path is tight, the tension of the thread take-up spring will shorten the upper thread.

The suitable tension of the bottom thread is: After the thread buckle fork is buckled, the bottom thread can be pulled by hand; Adjust the parameters, the opening angle, the larger the closing angle, the longer the face line. In addition, you can also take a test to tighten the cloth embroidery thread and realign the hook. Conditioned by the following methods: Introspect the thread, do not over tighten the thread take-up spring and knob; Adjust the height of the thread buckle, higher profile will make China Multifunction Mixed Embroidery Machine Manufacturers the upper thread longer, this thought is often useful in practical training Adjust the parameters, the opening angle, the larger the closing angle, the longer the face line.

As long as the thoughts on troubleshooting are targeted at the above: Sometimes when the weather is overheated, the needle is locked during the thread trimming operation, and cannot move upward. The solenoid valve that locks the needle continues to move twice, causing helplessness to cut the upper thread. There are two main types of short thread trimming results for computerized embroidery machines: short thread trimming upper thread and short thread trimming bottom thread.

In short, the main reasons for cutting the thread are the machine and the electronic control. At first, we should test some customary investigation plans, such as introspecting whether the reaming shears can achieve results, whether the reaming shears status can achieve results, whether the thread deduction can achieve results, whether the hook knife can achieve results, etc. Embroidery is a sticking point for embroidery